CELTO ACOUSTIQUE P 2.25

Spécifications techniques :Puissance :2x 1300W  8 ohms2x 2500W  4 ohms2 x 1200W  2 ohms not recommended1x 5000W  8 ohms (Bridge)1x 2400W  4 ohms (Bridge)Overall gain              : 34dB (50 times voltage)Sensitivity at 8 ohms : 1.8 Vrms (+6.3dBu)Signal to Noise Ratio (A weighted, 0dB) : >110dBFrequency Response (-1dB)                  : 10 - 25 000 HzTypical THD (half power, 1kHz, 8 ohms) : 20V/usInput Impedance      : 20 k&!Damping factor (1kHz, 8 ohms) : >800Protections               :  Soft-Start, Short-Circuit, Over and Under-Voltage, Over-Current, Over-Load, DC Output, Temperature, SOM (Smart Overhead Management)Operating Voltage     : 190~260VAC 50-60HzPreamp                    : Proprietary PureSound Circuit for unmatched sound quality (Audiophile capacitors in signal path, High Voltage Opamps, Ultra Low Noise design), Studio grade VCA limiter, Continuous protection, RF protection, Overload protectionPower Supply (PSU)  : Advanced Linear topology with tracking current, 105 C long life charges capacitorsOutput stage            : Fully Discrete 4th generation proprietary Class D (93% efficiency at full power)Half bridge design with high-Speed high-Current MOSFETs, 105C Long Life capacitorsCooling                    : Front to back airflow, Temperature regulated SUNON MagLev fans (50 000 hours dustproof), FEA optimized Radial heat-sink for maximum heat transferRear PanelSpeakon Wiring2 NEUTRIK XLR Input with latch,2 NEUTRIK XLR Link2 NEUTRIK Speakon NL4Stereo / Parallel / Bridge switchPower cable directly soldered (3x1.5mm without molded plugl)Speakon WiringSPK1 = 1+1- CH A / 2+2- CH BSPK2 =  1+1- CH B / 2+2- Not UsedDimensionsChassis : 19" 2U height, 388mm total depthPoids : 17 kgs